Kguard security dvr manual

In either recording or playback mode, pressing and holding the QUAD button for over 3 seconds will set the cycle through all of the channels one after the other in full screen display mode. If set to off, then the system password will not be needed to operate the system.

Note: Hard Drives always show a capacity which is less than their actual size. A 1TB drive will report as a GB drive.

Motion Setup: This sub menu allows the Motion Detection to be fine tuned. Channel Sensitivity: The sensitivity can be set for each channel, the options are from 1 High Sensitivity to 9 Low Sensitivity and Off which will not allow the channel to be triggered by movement.

Note: If you forget the system password, turn off the system and remove the Hard Drive. To playback an event from the list press the PLAY button on the highlighted event. Run the Setup program. Play Backwards Configuration Pause Print Play Event List Select an event from the list to play it back.

Open the file by clicking the folder icon and selecting the file you wish to playback. To configure the DVR system, click the icon. To play a video click the icon. Make sure that the power switch at the rear of the unit is switched on. Why is the DVR system responding slowly after boot up?

The DVR system will check all the data on the Hard Disk during when it is starting up, this will slow the system down. But when I plug into a computer via the USB port, why can I still see the files on the hard disk drive? The system allows for resetting of the hard drive for over-writing purposes.

Print page 1 Print document 30 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Log In Sign Up. Forgot password? Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Contents Contents Mobile Device Access Click FREE. Click OK. The utility software icon is displayed on the application screen.

Mobile Device Access 4 Click to open the Settings page and enter the required settings. Enter the password that you configured 5 Password in the DVR menu.

Using the Utility Software 1 2 4 3 No. Click the arrow buttons to move the camera direction for PTZ camera only. Buttons Click the icons to adjust the aperture for PTZ camera only. Click to adjust the camera focus for PTZ camera only.

Full Screen Button Click to view the channel in full screen. Settings Button Click to open the Settings page. Toggle Button Click to view more channel buttons. Mobile Device Access No. More channel buttons are available by clicking. Click Install. Login with your BlackBerry ID.

You can only view or download manuals with. Sign Up and get 5 for free.